Khaled Al-Saai Wall Art: Hanging and Care Guide

Quick answer

Hang a Khaled Al-Saai wall bowl only on a mount rated for its size and weight, fixed into a solid wall or stud. Clean it with a soft dry cloth and keep it away from direct heat, moisture, and knocks.

Step-by-step: hang and care for your wall bowl

1. 1. Inspect the piece before mounting: Unwrap the bowl on a padded surface and check the back and rim for any existing fittings, chips, or rough spots. Decide which part of the bowl should bear the mount's support. Common mistake: assuming the back has a factory hanging point when it may not. Photograph the back before mounting so you have a reference if you ever need to remount it.
2. 2. Choose a mount rated for the bowl: Select a porcelain-safe wall bracket or display mount sized for a 47 cm bowl and rated for its weight. Avoid adhesive strips and single small hooks. If the maker or a specialist framer can supply a custom cradle, that is the safer route for a unique piece. Common mistake: buying a mount by diameter alone without checking weight capacity. Keep the mount's instructions and weight rating with your household documents.
3. 3. Find a solid fixing point: Use a stud finder or probe the wall, and fix the mount into studs or with masonry anchors appropriate to your wall type. Mark the position with the bowl held in place by a helper before drilling. Common mistake: drilling into plasterboard alone, which can pull out under load. If you are unsure about the wall construction, stop and use a qualified installer.
4. 4. Mount and test with a gentle load: Attach the mount, then press down lightly and sideways to check for movement before adding the bowl. Lift the bowl with two hands at the rim and base, set it into the mount, and confirm it sits flush. Common mistake: hanging the bowl first and testing the mount afterwards. Recheck the mount's fixings after the first week and again after a month.
5. 5. Clean with a soft dry cloth: Dust the bowl with a clean microfiber cloth or a soft brush. For fingerprints, use a barely damp cloth and dry immediately. Do not use abrasive cleaners, scouring pads, or immersion. Common mistake: spraying cleaner directly onto the bowl, which can run behind the mount. Clean the wall and mount area before dusting the bowl so loosened dirt does not settle back on it.
6. 6. Keep the display stable long term: Avoid hanging the bowl where doors, bags, or furniture can knock it. Check the mount and wall fixings every few months, and remove the bowl before any painting, drilling, or redecorating nearby. Common mistake: leaving the bowl in place during nearby DIY work. Store the bowl flat on a padded shelf, not upright on its rim, if you take it down.

Product facts

• Wandschale Unikat "Untitled", Unikat Khaled Al-Saai, Ø 47 cm: Diameter: 47 cm. At this size, the bowl needs a wide, well-anchored mount rather than a small hook, and the wall area must be planned before drilling.